Brake system back in place.

This screw was too short ?

The clutch holes do not line up, lots of trial fit needed.

It's in. Except that the pedal touches the firewall before its bottom position :( I guess it needs some shortening ?

Support bracket for the pedals, good idea.

Except it has a 40mm horizontal and 50mm vertical offset !

There was no hole for the steering column.

lol

After the required adaptations :

Gaz pedal.

Driver side firewall.

Yes, the gas pedal is very close to the transmission tunnel ..

We'll see how that turns out.

Passenger side firewall.

Final pedal assembly.

Steering column and wheel.

Fuel circuit in the engine bay.

Done :

Fixation of the clutch line. A rigid line to the master cylinder is still required.

Coolant line from rear thermostat to radiator.

Fabricated support bracket.

Done :

The old electrovalve, some fab required.

Done :